Today was a busy day. Kyle had Jackie’s dad Don along to help today. We got a lot done today. Here’s what’s on the docket:

Remove and strip down the door-in-door door
Panel Removal
New Panel Installation (finally finishing it)
Beginning Roof Vent Removal

We started off by getting the door off the side of the Airstream and getting it laid down on a work surface. It looked like the door had been reattached at some point as evidenced by the use of low-quality steel pop rivets. This doesn’t work on a lot of levels. First, steel rusts. They had already begun to rust. Second, Pop rivets look terrible compared to buck or Olympic rivets. Third, they look awful. Fourth, they look awful. So, we drilled out the pop rivets and got the door laid out. In the process of looking more closely at the door, it was decided that both the interior and exterior skins of the door would look a lot better if they were new aluminum. So, here I am (Kyle) putting a large order into Airparts for some 2024-T3 AlClad .032 Aluminum. I’m getting pretty decent at this. Truth be told, I need a bunch of stuff from Airparts as you’ll see in the next couple couple paragraphs. Here’s a video of stripping down the interior panels from the door-in-door model.

Part 2 to come tomorrow will be about the surprise panel removal we made today! Stay tuned for more!